I began turning wood in Junior High School. While visiting an uncle in Southern California he noticed my excitement about wood turning and he gave me a lathe that he never used. With paper route earnings I purchased tools from Sears and my dad and I began turning on our midsized lathe.
After seeing pens in a woodworking store in Port Townsend I said to my wife “I could make that!” Years later I wandered into a store and discovered pen kits and asked how to make them. The owner gave me a three minute lesson and after purchasing the needed extras for the lathe I began my current wood turning adventures.
The real turning point was Eric giving me a rough turned Madrone burl bowl. That was so exciting to turn. Dave Schweitzer noticed my excitement and asked me to come and see him. He had no idea what he was in for. After a long day at Dave’s he finally got rid of me after six in the evening. This began a marathon of turning wet wood and learning and practicing the techniques that had been shown. Two hundred rough turned bowls later there were signs of hope in my finished bowls.
Back to Dave’s and now hollow forms started popping up at home. A day with Roy Lane helped that experience as well. So much to learn and so little time, with lots of practice happiness ensued. Urns, baby rattles and vases appeared, some with dyed and some natural finishes.
The many demonstrators at our club and others continued to teach techniques that were new to me. With practice these new methods became easier to use and enabled me to produce better results.